Specifications

4-2
Cisco ONS 15216 EDFA Operation Guide
78-12818-01
Chapter 4 Provisioning and Monitoring
Local Serial Communication Setup
Figure 4-1 HyperTerminal Connect To Dialog Box
3 Open HyperTerminal.
4Type
Optical Amplifier, select an icon, and click OK.
In the Connect To dialog box (Figure 4-1), Direct to Com1 must be selected in the
Connect using field. Click OK when done.
5 Configure the Port Settings in the COM1 Properties dialog box as shown in
Figure 4-2.
6 From the HyperTerminal menu bar, select File>Properties to display the Properties
dialog box. Click the Connect to tab (Figure 4-3).
Make sure that Direct to Com1 is selected in the Connect using field.
7 Click the Settings tab shown in Figure 4-4 and click the ASCII Setup button.
Configure the ASCII Setup window as shown in Figure 4-5.
8Click OK to return to the HyperTerminal main screen.
9 Set the address using the !xx syntax, where xx can be any value from 00 to 99. At the
prompt, login using the @xx syntax, where xx can be any value from 00 to 99.
10 Click Enter once.
Table 4-2 RS-232 Configuration (continued)
Step Description