Specifications

Contents
iv
Cisco ONS 15216 EDFA2/EDFA2-A Operations Guide, R2.4
July 2004
2.2 Electrical Specifications 2-4
2.3 Mechanical Specifications 2-4
2.4 External Features 2-5
2.5 Front Panel 2-6
CHAPTER 3 Installation 3-1
3.1 Standard Precautions 3-1
3.2 Placement and Power Connection 3-1
3.2.1 General Rack Considerations 3-1
3.2.2 Rack Installation and Power Supply Connection Procedures 3-2
3.3 SC/UPC Optical Ports 3-3
3.3.1 Safety Requirements 3-3
3.3.2 Optical Connection Procedure 3-4
3.3.3 Optical Amplification Operation Verification Procedure 3-4
3.4 Communications 3-5
3.4.1 Alarm Out Relay Interface (RJ-45) 3-5
3.4.1.1 Alarm Relay Connection Procedure 3-6
3.4.2 Alarm LEDs 3-6
3.4.2.1 POWER LED (Green) 3-6
3.4.2.2 FAIL LED (Red) 3-7
3.4.2.3 LOS LED (Yellow) 3-7
3.4.2.4 Ethernet Socket LEDs 3-7
3.4.3 Serial Interface (EIA/TIA-232) Communication 3-7
3.4.3.1 Required Equipment 3-7
3.4.3.2 Serial Connection Procedure 3-8
3.4.4 Serial Interface Remote Communication via Modem 3-11
3.4.4.1 Remote Communication Component Requirements 3-11
3.4.4.2 Modem Signals 3-12
3.4.4.3 Modem Power Up 3-12
3.4.4.4 Modem Configuration Settings 3-12
3.4.4.5 Setting and Saving Modem Settings 3-14
3.4.4.6 PC Connection via Modem 3-14
3.4.5 LAN Interface (Ethernet) 3-14
3.4.5.1 LAN Connection Procedure 3-15
CHAPTER 4 Provisioning with ASH and SNMP 4-1
4.1 Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal 4-1
4.2 Set IP Address 4-3