Specifications

9-68

Cisco ONS 15216 EDFA2/EDFA2-A Operations Guide, R2.4

July 2004

Chapter 9 TL1 Commands

9.6.43 SET-ATTR-DWDM

Command Types SET-ATTR-DWDM

Sets the alarm severity (notification code) that is reported when a DWDM alarm is raised or cleared

(derived from cerent15216EdfaAlarmState).

The notification code NA (Not Alarmed) reports a detected condition type by a REPT EVT message. The

condition can be retrieved with the RTRV-COND command. The notification code NR (Not Reported)

is not be reported by REPT EVT, but is retrievable via the RTRV-COND command.

Note The REPT ALM DWDM messages for Loss of Signal, Gain Out of Range, and Loss of Output Power

are prioritized (in the order just listed) so that only one message can be delivered at one time. This

prioritization is not affected by the provisioned alarm severity. For example, if the ONS 15216 EDFA2

detects both a loss of input signal and a loss of output power at the same time, it will deliver only the

Loss of Signal message to the user. This prioritized filtering of alarms does not occur with the SNMP

delivery of alarms on the ONS 15216 EDFA2.

Syntax Description

SET-ATTR-DWDM:[<TID>]:[<aid>]:<ctag>::[<ntfcncde>],[<condtype>][,,,];

Example 9-48 SET-ATTR-DWDM Command

Amp01:ONS15216 EDFA2>

SET-ATTR-DWDM:Amp01:ALL:123::CR,LOS;

Table 9-48 RTRV-USER-SECU Syntax Description

Parameter Syntax Description

sid string Source identifier uniquely identifies the source of a TL1

autonomous command.

al Access level of the user. See “9.5 Summary of Security

Permissions for TL1 Commands” section on page 9-6 for

access level permissions.

R Read only privileges.

RW Read and write privileges.

RWA Read, write, and administrative privileges.

uid string User identifier (user name) of the existing user. If no user

identifier is specified and the current user has RWA access

level, it will list all existing users and their security levels.