Specifications

9-31

Cisco ONS 15216 EDFA2/EDFA2-A Operations Guide, R2.4

July 2004

Chapter 9 TL1 Commands

9.6.19 REPT ALM EQPT

Command Types REPT ALM EQPT

Reports when a general alarm (not directly affecting optical signal) is logged or cleared (derived from

cerent15216EdfaAlarmState).

Syntax Description

<almcde> <atag> REPT ALM EQPT

"<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>,,:<conddescr>"

;

Example 9-21 REPT ALM EQPT Message

Amp01 2001-06-18 14:48:44

* 141 REPT ALM EQPT

"EQPT:MN,LCRNT1,NSA,6-18,14-48-44,,:\"Excessive Pump1 Current\""

;

Table 9-25 REPT ALM EQPT Syntax Description

Parameter Syntax Description

almcde The alarm severity code for the TL1 message. Possible values

are:

*C Critical alarm.

** Major alarm.

* Minor alarm.

A No alarm. Occurs only when ntfncde is NA.

atag 0 - 999 An integer between 0 and 999 used as a sequence number in

autonomous messages .

aid

Possible values are:

EQPT General parameters of the ONS 15216 EDFA2.

PWR-A Affecting Power Bus A.

PWR-B Affecting Power Bus B.

conddescr Detailed text description of the event. The conddescr is 1 to 64

characters of ASCII text. See condtype below.