Specifications

Cisco 12010, Cisco 12410, and Cisco 12810 Router Clock and Scheduler, Switch Fabric, and Alarm Card Replacement Instructions

OL-13810-01

Regulatory, Compliance, and Safety Information

Router uptime is 17 hours, 53 minutes

System returned to ROM by reload at 23:59:40 MET Mon Jul 2 2001

System restarted at 00:01:30 MET Tue Jul 3 2001

System image file is "tftp://172.17.247.195/gsr-p-mz.15S2plus-FT-14-May-2001"

cisco 12016/GRP (R5000) processor (revision 0x01) with 262144K bytes of memory.

R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache

Last reset from power-on

2 Route Processor Cards

1 Clock Scheduler Card

3 Switch Fabric Cards

1 8-port OC3 POS controller (8 POs).

1 OC12 POS controller (1 POs).

1 OC48 POS E.D. controller (1 POs).

7 OC48 POS controllers (7 POs).

1 Ethernet/IEEE 802.3 interface(s)

17 Packet over SONET network interface(s)

507K bytes of non-volatile configuration memory.

20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).

8192K bytes of Flash internal SIMM (Sector size 256K).

Router#show controller fia

Fabric configuration: Full bandwidth nonredundant

Master Scheduler: Slot 17

Additional troubleshooting information is available on Cisco.com.

Regulatory, Compliance, and Safety Information

This section includes regulatory, compliance, and safety information in the following sections:

• Translated Safety Warnings and Agency Approvals

• Electromagnetic Compatibility Regulatory Statements

Translated Safety Warnings and Agency Approvals

The complete list of translated safety warnings and agency approvals is available in the Regulatory

Compliance and Safety Information for Cisco 12000 Series Internet Routers publication.

(Document Number 78-4347-xx.)

Electromagnetic Compatibility Regulatory Statements

FCC Class B Compliance

The equipment described in this manual generates and may radiate radio-frequency energy. If it is not

installed in accordance with Cisco’s installation instructions, it may cause interference with radio and

television reception. This equipment has been tested and found to comply with the limits for a Class B

digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are

designed to provide reasonable protection against such interference in a residential installation.

However, there is no guarantee that interference will not occur in a particular installation.