Specifications

Chapter 3 Configuration
Server Setup
3-48
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
• Read .ini File from File Server
• BOOTP Server Timeout (sec)
• DHCP Multiple-Offer Timeout (sec)
• DHCP Requested Lease Duration (min)
• DHCP Minimum Lease Duration (min)
• DHCP Class Identifier
Configuration Server Protocol
Use the Configuration Server Protocol pull-down menu to select your network’s
method of IP address assignment. The menu contains the following options:
• None—Your network does not have an automatic system for IP address
assignment.
• BOOTP—Your network uses Boot Protocol, in which IP addresses are
hard-coded based on MAC addresses.
• DHCP—With Dynamic Host Configuration Protocol, IP addresses are leased
for a period of time. You can set the lease duration with the settings on this
page.
Use Previous Configuration Server Settings
Select yes to have the access point save the boot server’s most recent response.
The access point uses the most recent settings if the boot server is unavailable.
Read .ini File from File Server
Use this setting to have the access point use configuration settings in an .ini file
on the BOOTP or DHCP server or the default file server. Files with .ini extensions
usually contain configuration information used during system start-up. The
pull-down menu contains the following options:
• Always—The access point always loads configuration settings from an .ini
file on the server.
• Never—The access point never loads configuration settings from an .ini file
on the server.