Specifications

Chapter 3 Configuration
Radio Configuration
3-18
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Radio Configuration
This section describes how to configure the access point’s radio. You use the AP
Radio pages in the management system to set the radio configuration. The radio
pages include:
• AP Radio Identification—Contains the basic locating and identity
information for the access point Radio port. See the “Entering Identity
Information” section on page 3-18 for instructions on using the AP Radio
Identification page.
• AP Radio Hardware—Contains settings for the access point’s SSID, data
rates, transmit power, antennas, radio channel, and operating thresholds. See
the “Entering Radio Hardware Information” section on page 3-21 for
instructions on using the AP Radio Hardware page.
• AP Radio Advanced—Contains settings for the operational status of the
access point’s radio port. You can also use this page to make temporary
changes in port status to help with troubleshooting network problems. See the
“Entering Advanced Configuration Information” section on page 3-29 for
instructions on using the AP Radio Advanced page.
• AP Radio Port—Lists key information on the access point’s radio port.
Entering Identity Information
You use the AP Radio Identification page to enter basic locating and identity
information for the access point radio. Figure 3-10 shows the AP Radio
Identification page.