Specifications

4-35
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 4 Security Setup
Summary of Settings for Authentication Types
Table 4-5 Settings for Authentication Types
Authentication Types Required Settings
LEAP On the Authenticator Configuration page (shown in Figure 4-13):
• Select an 802.1x protocol draft that matches the protocol draft used by
client devices that associate with the access point.
• Enter the name or IP address, type, port, shared secret, and timeout
value for your RADIUS server.
• Select the EAP check box under the server.
On the AP Radio Data Encryption page (shown in Figure 4-6):
• Select the Network-EAP check box.
• Enter a WEP key in key slot 1 and select 128-bit from the key size
menu.
LEAP and static WEP
under 802.11 Open
• Enter all the settings for LEAP authentication.
On the AP Radio Data Encryption page (shown in Figure 4-6):
• Select the Open check box.
EAP-TLS and EAP-MD5 On the Authenticator Configuration page (shown in Figure 4-13):
• Select an 802.1x protocol draft that matches the protocol draft used by
client devices that associate with the access point.
• Enter the name or IP address, type, port, shared secret, and timeout
value for your RADIUS server.
• Select the EAP check box under the server.
On the AP Radio Data Encryption page (shown in Figure 4-6):
• Select the Open and Network-EAP check boxes.
• Select the Require EAP check box under Open.
Note Selecting Require EAP blocks non-EAP client devices from
using the access point.
• Enter a WEP key in key slot 1 and select 128-bit from the key size
pull-down menu.