Specifications

Cisco 12016, Cisco 12416, and Cisco 12816 Router Clock and Scheduler, Switch Fabric, and Alarm Card Replacement Instructions

OL-13811-01

Regulatory, Compliance, and Safety Information

This section includes regulatory, compliance, and safety information in the following sections:

• Translated Safety Warnings and Agency Approvals

• Electromagnetic Compatibility Regulatory Statements

Translated Safety Warnings and Agency Approvals

The complete list of translated safety warnings and agency approvals is available in the Regulatory

Compliance and Safety Information for Cisco 12000 Series Internet Routers publication.

(Document Number 78-4347-xx.)

Electromagnetic Compatibility Regulatory Statements

FCC Class B Compliance

The equipment described in this manual generates and may radiate radio-frequency energy. If it is not

installed in accordance with Cisco’s installation instructions, it may cause interference with radio and

television reception. This equipment has been tested and found to comply with the limits for a Class B

digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are

designed to provide reasonable protection against such interference in a residential installation.

However, there is no guarantee that interference will not occur in a particular installation.

Modifying the equipment without Cisco’s written authorization may result in the equipment no longer

complying with FCC requirements for Class B digital devices. In that event, your right to use the

equipment may be limited by FCC regulations, and you may be required to correct any interference to

radio or television communications at your own expense.

You can determine whether your equipment is causing interference by turning it off. If the interference

stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment

causes interference to radio or television reception, try to correct the interference by using one or more

of the following measures:

• Turn the television or radio antenna until the interference stops.

• Move the equipment to one side or the other of the television or radio.

• Move the equipment farther away from the television or radio.

• Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is,

make certain the equipment and the television or radio are on circuits controlled by different circuit

breakers or fuses.)

CISPR 22

This apparatus complies with CISPR 22/EN55022 Class B radiated and conducted emissions

requirements.