Specifications

4-5
Content Services Switch Getting Started Guide
78-11766-01
Chapter 4 Configuring the CSS
Using the Configuration Script
##############################################
#Setup Script for the Content Services Switch#
##############################################
Checking for Existing Config...
No startup-config was found, continue with the setup script [y/n]?
y
Note: Pressing “q” after any prompt quits setup. Pressing <CR>
after any [y/n] defaults to “y”.
Warning: All circuit VLAN IP addresses must be on a different
subnet than the Ethernet Mgt port IP address. The existing
Ethernet Mgt port IP address is: 10.0.4.251
Add an IP address to VLAN1: [default = 192.168.10.1] 192.168.3.6
Add an IP subnet mask to VLAN1: [default = 255.255.255.0]
Warning: The default gateway IP address must be on the same subnet
as VLAN1. VLAN1 IP address is: 192.168.3.6
Add IP address for default gateway: [default = 192.168.3.2]
192.168.3.3
Pinging the default gateway: 100% Success.
Which feature do you want to configure?
[1] Layer3 load balancing
[2] Layer5 load balancing
[3] Proxy cache
[4] Transparent cache
[5] Exit script
If you select option 5 to exit the script, the CSS saves the information you entered
to the running-config and then displays the running-config.