Specifications

Chapter 2 Cabling the CSS
Connecting Power Cords
2-34
Content Services Switch Getting Started Guide
78-11766-01
Figure 2-20 Location of CSS 11800 DC Power Supply Connectors
.
2. Using a flat-head screwdriver, loosen the captive screws on the three DC
connectors (labeled from left to right,+, –, and , respectively).
Warning Before installing a wire, ensure that the polarity of the DC
connections is correct. Reversed polarity can create a dangerous
shock hazard and cause damage to the DC power source.
3. Install the wires into the appropriate connector. Make sure that the
uninsulated part of each wire is 9mm (0.35 in.) in length.
When installing the wires, always connect the ground wire first. When
disconnecting the wires, always disconnect the ground wire last.
–
+
PS1 DC
Terminal block
PS1 DC
Terminal block
49593
.35"
(9mm)