Specifications

2-29
Content Services Switch Getting Started Guide
78-11766-01
Chapter 2 Cabling the CSS
Connecting Power Cords
Connecting a CSS 11050 or CSS 11150 AC Power Cord
To connect an AC power cord to a CSS 11050 or CSS 11150:
1. Ensure that the CSS power switch is in the 0 (off) position.
2. Attach the power cord to the CSS by plugging the AC power cord connector
into the power receptacle at the rear panel, as shown in Figure 2-17
Figure 2-17 Connecting a CSS 11050 or CSS 11150 AC Power Cord
.
3. Plug the power cord into a dedicated 3-wire grounding receptacle.
4. Switch on the power on the CSS.
Connecting a CSS 11150 DC Power Cord
Before you install a DC power cord, refer to Appendix A, Specifications for DC
power supply safety warnings.
Warning The DC power supply cord requires 18 AWG wire. The CSS 11150
draws a maximum of 25 amps.
Warning DC systems do not have a power switch. A chassis configured for
DC power requires an external power disconnect device (such as
an external circuit breaker).
AC -100 -240 VAC
50 - 60HZ 3.1A Max.
300W Max.
Power switch
AC power cord
49590