Specifications

Chapter 2 Cabling the CSS
Cabling the CSS 11800 Modules
2-22
Content Services Switch Getting Started Guide
78-11766-01
Gigabit Ethernet Module LEDs
The GEM front panel LEDs indicate module status (Power, Status, and Ready
LEDs) and network status for each of the connectors (Transmit, Receive, and Link
LEDs). Table 2-7 describes the GEM LEDs
.
Switch Fabric Module (SFM and SFM2) Connectors and LEDs
The Switch Fabric Module (SFM or SFM2) sets up and tears down flow
connections, monitors switch operation, and performs switch functions. The I/O
modules use the SFM processors to perform routing functions, including
resolution of unknown addresses, route determinations, protocol processing, and
other exception events.
Table 2-7 Gigabit Ethernet Module LED Descriptions
LED Name Color LED Status Indicates
Power Green Off Module does not have power
On Module has power
Status Yellow Off Module is operational
On Module is experiencing an error
Ready Green Off Module not initialized
On Module initialized and ready
Tx (Transmit)
(Ports 1 to 4)
Green Off No transmit packet activity
Blinking Transmit activity detected
Rx (Receive)
(Ports 1 to 4)
Green Off No receive packet activity
Blinking Receive activity detected
Link/Sync
(Ports 1 to 4)
Green Off No link
On Link exists and synchronization
achieved
Blinking Link exists but not synchronized