Specifications

2-17
Content Services Switch Getting Started Guide
78-11766-01
Chapter 2 Cabling the CSS
Cabling the CSS 11800 Modules
Configuring a Terminal to the SCM Console Port
This section describes how to configure a terminal connected to the SCM console
port. Initially, the terminal settings must match the CSS default settings as
specified in Table 2-5.
Fast Ethernet Module Connectors and LEDs
The FEM is available in two models:
Model CSS8-IOM-8FE contains 8 RJ-45 Fast Ethernet 10/100-Mbps
10BASE-T/100BASE-TX connectors
Model CSS8-IOM-6/2FE contains 6 RJ-45 Fast Ethernet 10/100-Mbps
10BASE-T/100BASE-TX connectors and 2 100BASE-FX SC fiber
connectors
Each model contains Power, Status, and Ready LEDs for module status and
Duplex, Speed, and Link LEDs for each of the 8 connectors. Figure 2-11
illustrates the LEDs and connectors on the 8-port FEM.
Table 2-5 CSS Console Port Default Settings
Parameter Default Setting
Baud Rate 9600
Data Bits 8
Flow Control none
Parity none
Stop Bits 1
Terminal Type VT100/ANSI