Specifications

Chapter 1 Unpacking and Installing the CSS
Installing a CSS 11800 Module
1-20
Content Services Switch Getting Started Guide
78-11766-01
Figure 1-8 Installing a Module into a CSS 11800 Chassis
4. Close both ejectors simultaneously to seat the module connector into the
backplane.
5. Using a Phillips screwdriver, tighten the spring-loaded screws on the front of
the module faceplate. Once you install the module, it begins diagnostics and
initializes automatically.
If you installed a SFM or SFM2, you must reboot the chassis to activate it.
6. If you are installing additional GBICs in a Gigabit Ethernet module, position
the GBIC with its receive connector above its transmit connector.
49573