Specifications

1-11
Content Services Switch Getting Started Guide
78-11766-01
Chapter 1 Unpacking and Installing the CSS
Installing the CSS 11800
4. Repeat steps 1 through 3 to install the second bracket onto the other side of
the chassis.
When the brackets are in position for mounting the chassis in a rack, proceed to
the “Rack-Mounting the CSS 11800 Chassis”.
Extend-Mounting the CSS 11800 Brackets
You can extend-mount a CSS 11800 chassis to set the front edge of the unit behind
the front edge of the rack to allow the chassis to be installed in an enclosed rack.
Before you can extend-mount a chassis, you need to reposition its mounting
brackets. Each bracket has two sets of screw holes. The set of holes you use to
install the brackets to the chassis determines how the chassis is mounted in a rack:
The screw holes toward the front of the bracket position each bracket on the
CSS 11800 chassis for front mounting in a cabinet; this is the preinstalled
position.
The screw holes behind the first set of holes position each bracket on the
CSS 11800 chassis for extended mounting in a cabinet.
Figure 1-5 illustrates extend-mounting the brackets.