Specifications

5-5
Book Title
78-13113-06 B0
Chapter 5 Troubleshooting the Uplink Cards
LEDs
The LEDs located on the right side of the uplink card provide system status information.
Note Table 5-5 also indicates the system status of the card as it initializes.
PROTECT
Green Remote wrap.
Off No wrap.
Amber Local wrap.
Blinking green Remote steer.
Blinking amber Local steer.
Table 5-4 RPR/SRP Uplink Status LEDs (continued)
LED Activity Description
Table 5-5 RPR/SRP Uplink Card System LEDs
LED Activity Description
OVERTEMP
Green (default status
when initialized)
System is operating within the proper temperature range.
(inlet <104
o
F [40
o
C]; outlet <109
o
F [43
o
C])
Amber/green Both LEDs are on, (appears orange). System is working
on warning temperature range.
(104
o
F [40
o
C] <= inlet < 122
o
F [50
o
C],
109
o
F [43
o
C] <= outlet < 127
o
F [53
o
C])
Amber System is working on critical temperature state.
(122
o
F [50
o
C] <= inlet < 149
o
F [65
o
C],
127
o
F [53
o
C] <= outlet < 167
o
F [75
o
C])
CARD FAIL
Amber A hardware failure is detected on the uplink card. During
power up, the LED will be amber even when the uplink
card is powered down.
Off (default status
when initialized)
Card is operational. The LED is turned off after hardware
initialization.
SYSTEM STATUS
Amber Not applicable.
Amber/green Both LEDs are on (appears orange). This is the normal
configuration during power up. Once the software loads
successfully, the amber LED will turn off.
Green (default status
when initialized)
System is operational.
POWER
Green (default status
when initialized)
Uplink card is receiving power from the system.
1
1. System power up is not an indication that the uplink card is powered up. Check the card status LEDs to ensure the card is
functioning properly and is receiving power from the system.
Off Uplink card is not receiving power from the system.