Specifications

3-8
Book Title
78-13113-06 B0
Chapter 3 Installing and Removing the Uplink Cards
Removing the Uplink Card
Removing the Uplink Card
Use the instructions in this section to remove an uplink card.
Step 1 Remove any console port cable or auxiliary port cable from the card.
Figure 3-9 Spring-Loaded Screws on the Uplink Card
Step 2
Locate the spring-loaded screws on the front of the uplink card. (See Figure 3-9.)
Step 3 Using the Number 1 Phillips screwdriver, unscrew the spring-loaded screws by turning them
counterclockwise.
Figure 3-10 Removing Uplink Card from Router Chassis
Step 4
Grasp the spring-loaded screws and gently move the card back and forth until it disengages from the
midplane.
Step 5 When the card disengages from the midplane, pull the card straight out. (See Figure 3-10.)
1 Uplink card spring-loaded screws
AC O
K
D
C O
K
O
TF
AC OK
DC O
K
OTF
INPUT 100-200- 50/60Hz 2-5A
DO
N
N
O
T R
E
M
O
V
E
O
R
INS
E
R
T C
A
B
LE
S
W
ITH
TH
E
P
O
W
E
R
O
N
CARD FAIL
CARD FAIL
LINK/ACTIVE (G)
10
0 MBPS
POWER
RESET
CONSOLE
AUX
OVERTEMP
ACTIVE
CARD FAIL
SYSTEM STAUS
POWER
CARRIER
RX PKT
WRAP
PASS THRU
57687
1
57747
DON NOT REMOVE
OR INSERT CABLES
WITH THE POWER ON
CARD FAIL
CARD FAIL
LINK/ACTIVE (G)
100 MBPS
POWER
RESET
CONSOLE
AUX
OVERTEMP
ACTIVE
CARD FAIL
SYSTEM STAUS
POW
ER
CARRIER
RX PKT
W
RAP
PASS THRU