User guide

Installing the Cisco 1005 2-9
Connecting to the Network and Powering Up the Router
Installing the Flash Memory Card
This section explains how to install an optional PCMCIA Flash memory card. If you did
not order a Flash memory card, skip this section and proceed to the next section,
“Connecting the Network Interface Cables.”
To install the optional Flash memory (PCMCIA) card, perform the following steps:
Step 1 While pressing down on the two tabs at the top of the PCMCIA door, rotate the
top of the door away from the rear panel, lift it off, and place it aside. (See
Figure 2-4.)
Figure 2-4 Removing the PCMCIA Door
H3124
12VDC
Tabs