User guide

2-8 Cisco 1005 User Guide

Connecting to the Network and Powering Up the Router

After installing the router, install the Flash memory card (optional), connect the interface

cables, and then connect the power supply. All the connectors are on the rear panel of the

router. (See Figure 2-3.) The connectors, from left to right, are as follows:

• 10BaseT port (RJ-45)

• Console port (EIA/TIA-232) (RJ-45)

Note EIA/TIA-232 and EIA/TIA-449 were known as recommended standards RS-232

and RS-449 before their acceptance as standards by the Electronic Industries Association

(EIA) and Telecommunications Industry Association (TIA).

• Serial port (DB-60)

• PCMCIA slot (Flash memory card)

• DC power input port (12 VDC)

Figure 2-3 Rear Panel

H3779

PCMCIA

10BaseT

Serial

12VDC

Console

DC power

input