User guide

Installing the Cisco 1005 2-15
Connecting to the Network and Powering Up the Router
Step 2 Connect the other end of the Ethernet cable to your Ethernet network. You can
connect the Ethernet port in one of two ways:
• Connect a straight-through 10BaseT cable to a 10BaseT hub. (See Figure 2-9.)
(For cable pinouts, refer to Table A-2 in the appendix “Cable Pinouts.”)
• Connect the crossover 10BaseT cable to a PC network interface card. (See
Figure 2-10.) (For cable pinouts, refer to Table A-3 in the appendix “Cable
Pinouts.”)
Figure 2-9 Connecting to a 10BaseT Hub
12VDC
H3821
AUI
8
7
1
Cisco 1005
10BaseT hub
Straight-through
10BaseT cable