Specifications
Cisco 7200 Series
Cisco Site Preparation Guide
3-26
Cisco 7200 Series
Following are the physical specifications and external connection requirements for the Cisco 7200
series. The Cisco 7200 series includes the Cisco 7204 and Cisco 7206 routers.
Physical Specifications
Table 33 lists the physical specifications for the Cisco 7204 and the Cisco 7206 routers.
Table 3-20 Physical Specifications
1. Btu = British thermal units.
2. VAC = volts alternating current.
3. A = ampere.
4. Hz = hertz.
5. AWG = American Wire Gauge.
6. VDC = volts direct current.
7. cfm = cubic feet per minute.
Description Specification
Dimensions (H x W x D) 5.25 in. x 16.8 in. x 17 in. (13.34 cm x 42.67 cm x 43.18 cm)
Weight Chassis fully configured with a network processing engine, I/O controller, 6 port adapters,
2 power supplies, and a fan tray: ~ 50 lb (22.7 kg)
Heat dissipation 370W (1262 Btu
1
)
AC-input power 370W maximum (with either a single or dual power supply configuration)
AC-input voltage rating 100-240 VAC
2
wide input with power factor correction
AC-input current rating Not to exceed 5A
3
max at 100 VAC and 2.5A max at 240 VAC with chassis fully
configured
AC-input frequency
rating
50/60 Hz
4
AC-input cable 18 AWG
5
three-wire cable, with a three-lead IEC-320 receptacle on the power supply end,
and a country-dependent plug on the power source end
DC-output power 280W maximum (with either a single or dual power supply configuration)
DC-input power 370W maximum (with either a single or dual power supply configuration)
DC-input voltage rating –48 VDC
6
nominal in North America
–60 VDC nominal in the Europe Community
DC-input current rating Not to exceed 13A maximum at –48 VDC (370W/–48 VDC = 7.7A typical draw)
Not to exceed 8A maximum at –60 VDC (370W/–60 VDC = 6.2A typical draw)
DC voltages supplied
and maximum,
steady-state current
ratings
+5.2V @ 30A
+12.2V @ 9A
–12.0V @ 1.5A
+3.5V @ 13A
DC-input cable 14 AWG (2.08 mm) recommended minimum, with at least three conductors rated for at
least 140 F (60 C)
Airflow ~80 cfm
7
Temperature 32 to 104 F (0 to 40 C) operating; -4 to 149 F (-20 to 65 C) nonoperating
Humidity 10 to 90% noncondensing
Agency approvals Safety: UL 1950, CSA 22.2 No. 950, EN60950, AUSTEL TS001, AS/NZS 3260, IEC 950
EMI: FCC Class A, CSA Class A, EN60555-2, EN55022 Class B, VCCI Class 2,
AS/NRZ 3548 Class A
Immunity: IEC-1000-4-2, IEC-1000-4-3, IEC-1000-4-4, IEC-1000-4-5, IEC-1000-4-6,
IEC-1000-4-11, IEC 1000-3-2