Specifications

System Specifications 3-13
Cisco ConfigMaker Specifications
Note The serial WAN interface card uses a universal high-density, 60-pin receptacle. Each
universal port requires a serial port adapter cable that determines the port’s electrical interface type
(EIA/TIA-232, EIA/TIA-449, V.35, X.21) and mode: DTE or DCE. Although all port adapter cables
use a universal plug at the quad serial module end, the network end of each cable type uses the
physical connectors commonly used for the interface. (For example, the network end of the
EIA/TIA-232 port adapter cable is a DB-25 connector, the most widely used EIA/TIA-232
connector.)
• IEEE 802.3 Ethernet attachment unit interface (AUI) using a DB-15 connector
• IEEE 802.3 Ethernet 10BaseT using an RJ-45 connector
• Unshielded twisted-pair (UTP) and shielded twisted-pair (STP), IEEE 802.5 Token Ring using
DB-9 connectors
• Basic Rate Interface (BRI) using RJ-45 connectors; the Network Termination 1 (NT1) circuitry
is included in the router
Caution To prevent damage to the system, make certain you connect the BRI cable to the BRI connector
only and not to any other RJ-45 connector.
• Channelized E1/Primary Rate Interface (PRI)
• Cisco Systems makes four cables for the CE1/PRI modules. All four have DB-15 connectors on
the CE1/PRI end and either BNC, DB-15, Twinax, or RJ-45 connectors on the network end.
• Channelized T1/PRI (on the CT1/PRI module only) using DB-15 connectors (for null-modem
and straight-through cabling)
• Channelized T1/PRI-CSU (on the CT1/PRI-CSU module only) using a straight-through
RJ-48C-to-RJ-48C cable to connect the T1 port to an RJ-48C jack
Cisco ConfigMaker Specifications
Cisco ConfigMaker is a wizards-based software tool that helps you to quickly and easily configure
and address the Cisco 1000, 1600, 2500, and 3600 products. The Cisco ConfigMaker CD-ROM
ships in the software feature pack for these products, or it can be downloaded from the following
URL:
Table 3-4 contains the specifications for ConfigMaker.
Table 3-14 Cisco ConfigMaker Specifications
Description Minimum Requirements
Operating system Windows 95 or Windws NT 4.0
Processor Pentium or equivalent 486 computer
Hard disk space 12 MB
RAM 16 MB
Monitor SVGA with 640 x 460 pixels, 256 colors
Drives CD-ROM