Router Installation Guide

3-15
Cisco XR 12410 Router Installation Guide
OL-13832-01
Chapter 3 Installing the Cisco XR 12410 Router
Rack-Mounting the Router Chassis
Step 2 Starting at slot CSC0:
a. Pivot the ejector levers to unseat the card from the backplane connector
(
Figure 3-10).
b. Slide the card out of the slot and place it directly into an antistatic bag or other
ESD-preventive container.
Figure 3-10 Removing a Card from the Switch Fabric and Alarm Card Cage
Step 3 Repeat Step 2 for each card.
Step 4 Close the air filter door and tighten the captive screws to prevent the door from
opening during the chassis installation.
Rack-Mounting the Router Chassis
The router chassis can be installed in either a front-mounted position or a
center-mounted position as shown in
Figure 3-11.
ALARM
2
S
F
C
53270
Air filter door
-3/STM-POS
6DS3–SMB P
/
H
/
F
12DS3–SMB P
/
H
/
F
-48/STM-16-SCPOS
OC-12/STM-4 ATM
ST ETERNET
E PROCESSOR
Clock scheduler card