Router Installation Guide

3-37
Cisco XR 12406 Router Installation Guide
OL-13831-01
Chapter 3 Installing the Cisco XR 12406 Router
Manually Booting the System
RP Interfaces Using the RP LEDs
The Cisco XR 12000 series router uses the Performance Route Processor (PRP2).
Note When not explicitly specified, this publication uses the term route processor (RP)
to indicate the PRP.
The RJ-45 port LEDs on the RP indicate the following conditions:
• System and RP status
• Which Flash memory card slot is active
• Which Ethernet connection is in use
• What is occurring on the Ethernet interface
The alphanumeric LED displays indicate a successful RP boot.
RP
UP
A valid Cisco IOS XR image is running. RP IOS
XR
software
PRI
RP
The RP is enabled and recognized as the system primary.
A valid Cisco IOS XR image is running.
RP IOS
XR
software
SEC
RP
The RP is enabled and recognized as the system
secondary. A valid Cisco IOS XR image is running.
RP IOS
XR
software
1. The version of MBus microcode running on your system might be different.
Table 3-7 LED Display Meaning and Signal Source (continued)
LED
Display Meaning Source