USER GUIDE Wireless-N USB Network Adapter Model: WUSB300N
About This Guide About This Guide Icon Descriptions While reading through the User Guide you may see various icons that call attention to specific items. Below is a description of these icons: NOTE: This check mark indicates that there is a note of interest and is something that you should pay special attention to while using the product. WARNING: This exclamation point indicates that there is a caution or warning and it is something that could damage your property or product.
Table of Contents Chapter 1: Product Overview 4 Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 USB Extension Base . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Chapter 2: Wireless Security Checklist 5 General Network Security Guidelines . . . . . . . . . . . . . . . . . . . . .
Table of Contents Wireless-N USB Network Adapter iii
Product Overview Chapter 1 Chapter 1: Product Overview USB Extension Base Thank you for choosing the Wireless-N USB Network Adapter. Setting up your network and your Wireless-N USB Network Adapter is easier than ever. How does the Adapter do this? Like all wireless products, the Adapter allows for greater range and mobility within your wireless network, especially with the Wireless-N (802.11n) standard. Expect excellent range and mobility with the Wireless-G (802.11g) or Wireless-B (802.
Wireless Security Checklist Chapter 2 Chapter 2: Wireless Security Checklist Wireless networks are convenient and easy to install, so homes with high-speed Internet access are adopting them at a rapid pace. Because wireless networking operates by sending information over radio waves, it can be more vulnerable to intruders than a traditional wired network. Like signals from your cellular or cordless phones, signals from your wireless network can also be intercepted.
Configuration Chapter 3 Chapter 3: Configuration Ad-Hoc Mode or Infrastructure Mode The screen indicates whether the Adapter is currently working in ad‑hoc or infrastructure mode. Configuration is done through the Wireless Network Monitor (the Monitor). You can use the Monitor to check the link information, search for available wireless networks, or create profiles that hold different configuration settings. Link Quality The Link Quality bar indicates the quality of the wireless network connection.
Configuration Chapter 3 MAC Address This is the MAC address of the wireless network’s access point or wireless router. Transmit Power This is the power output at which the Adapter transmits. Signal Strength The Signal Strength bar indicates the signal strength. Up Time This indicates the length of the most recent connection to a wireless network. Link Quality The Link Quality bar indicates the quality of the wireless network connection.
Configuration Chapter 3 Network Type This is the network type used by your wireless network. Radio Band This is the radio band used by your wireless network. Security This is the status of the wireless security feature. MAC Address This is the MAC address of the wireless network’s access point. Refresh Click Refresh to perform a new search for wireless devices. Connect To connect to one of the networks on the list, select the wireless network, and click Connect.
Configuration Chapter 3 Create a New Profile The next screen is the Available Wireless Networks screen. Profiles Profile This is the name of the profile. Wireless Network Name This is the SSID or unique name of the wireless network. Profile Information For each profile selected, the following are listed: Wireless Mode This is the mode of the wireless network currently in use. Wide Channel This displays the Wireless-N primary channel used with a 40 MHz radio band network.
Configuration Chapter 3 WEP (Wired Equivalent Privacy) If you have WEP enabled, this screen appears. Select 64‑Bit or 128-Bit. Then enter a passphrase or WEP key. Pre-shared Key Enter a Pre-shared Key of 8-63 characters in the Pre-shared Key field. Click Connect and proceed to Step 3. WPA2 Personal If the network has WPA2-Personal wireless security enabled, then you will see the WPA2-Personal Needed for Connection screen. Enter the network’s Passphrase or pre-shared key in the Passphrase field.
Configuration Chapter 3 Network Settings Congratulations Congratulations! The profile is successfully configured. Advanced Setup If your network is not listed with the available networks, you can use Advanced Setup. If your network has a router or other DHCP server, select Obtain network settings automatically (DHCP). If your network does not have a DHCP server or router, select Specify network settings. Enter an IP Address, Subnet Mask, Default Gateway, and DNS addresses appropriate for your network.
Configuration Chapter 3 Click Next to continue. Click the Back button to change any settings. 5. If your wireless network doesn’t have wireless security, select Disabled and then click Next to continue. Proceed to Step 6. Wireless Mode Infrastructure Mode Use this mode if you want to connect to a wireless router or access point. If your wireless network has wireless security, select the method of security used: WEP, WPA Personal, WPA2 Personal, WPA Enterprise, WPA2 Enterprise, or RADIUS.
Configuration Chapter 3 Advanced Users TX Key The default transmit key number is 1. If your network’s access point or wireless router uses transmit key number 2, 3, or 4, select the appropriate number from the TX Key drop-down box. Authentication The default is set to Auto, so it will auto‑detect for Shared Key or Open System authentication. For Shared Key authentication, both the sender and the recipient share a WEP key for authentication.
Configuration Chapter 3 Server Name Enter the name of the authentication server here. EAP-TLS Certificate Select the Certificate installed to authenticate you on your wireless network. Encryption Select the encryption type from the Encryption drop-down menu. Click Next to continue or Back to return to the previous screen. PEAP WPA2 Enterprise - EAP-TLS Login Name Enter the login name of your wireless network here. Server Name Enter the name of the authentication server here.
Configuration Chapter 3 Certificate Select the certificate installed to authenticate you on your wireless network. PEAP Inner Authen. The authentication method used inside the PEAP tunnel. Click the Next button to continue or the Back button to return to the previous screen. RADIUS RADIUS features use of a RADIUS server. (This should only be used when a RADIUS server is connected to the Router.) RADIUS offers two authentication types: EAP-TLS and PEAP.
Configuration Chapter 3 7. The Congratulations screen appears next. Click Finish. Congratulations! Congratulations! The profile is successfully configured.
Appendix A Troubleshooting Appendix A: Troubleshooting Your computer does not recognize the Adapter. Make sure that the Adapter is properly inserted into the USB slot. The Adapter does not work properly. Remove the Adapter, and then reinsert it into the computer’s USB slot. Your computer cannot communicate with the other computers linked via Ethernet in the Infrastructure configuration. 1. Make sure that the computers are powered on. 2.
Specifications Appendix B Appendix B: Specifications Model WUSB300N Ports USB Port LEDs Power, Link/Act Detachable (Yes/No) No Modulations 802.11b: CCK, QPSK, BPSK 802.11g: OFDM Wireless-N: BPSK, QPSK, 16-QAM, 64-QAM RF Pwr (EIRP) in dBm 802.11b: 14±1 dBm (Typical) 802.
Appendix C Appendix C: Warranty Information Limited Warranty Linksys warrants this Linksys hardware product against defects in materials and workmanship under normal use for the Warranty Period, which begins on the date of purchase by the original end-user purchaser and lasts for the period specified below: •• One (1) year for new product •• Ninety (90) days for refurbished product This limited warranty is non-transferable and extends only to the original end-user purchaser.
Appendix C Warranty Information rejected. Do not include any other items with the product you are returning to Linksys. Defective product covered by this limited warranty will be repaired or replaced and returned to you without charge. Customers outside of the United States of America and Canada are responsible for all shipping and handling charges, custom duties, VAT and other associated taxes and charges.
Regulatory Information Appendix D Appendix D: Regulatory Information FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Appendix D Regulatory Information Industry Canada Statement Wireless Disclaimer This Class B digital apparatus complies with Canadian ICES-003. The maximum performance for wireless is derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range and coverage.
Appendix D User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste Electric and Electronic Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of Linksys products.
Appendix D Regulatory Information Eesti (Estonian) - Keskkonnaalane informatsioon Euroopa Liidus asuvatele klientidele Français (French) - Informations environnementales pour les clients de l’Union européenne Euroopa Liidu direktiivi 2002/96/EÜ nõuete kohaselt on seadmeid, millel on tootel või pakendil käesolev sümbol , keelatud kõrvaldada koos sorteerimata olmejäätmetega. See sümbol näitab, et toode tuleks kõrvaldada eraldi tavalistest olmejäätmevoogudest.
Appendix D Regulatory Information Lietuvškai (Lithuanian) - Aplinkosaugos informacija, skirta Europos Sąjungos vartotojams Nederlands (Dutch) - Milieu-informatie voor klanten in de Europese Unie Europos direktyva 2002/96/EC numato, kad įrangos, kuri ir kurios pakuotė yra pažymėta šiuo simboliu (įveskite simbolį), negalima šalinti kartu su nerūšiuotomis komunalinėmis atliekomis. Šis simbolis rodo, kad gaminį reikia šalinti atskirai nuo bendro buitinių atliekų srauto.
Appendix D Regulatory Information Português (Portuguese) - Informação ambiental para clientes da União Europeia Slovenščina (Slovene) - Okoljske informacije za stranke v Evropski uniji A Directiva Europeia 2002/96/CE exige que o equipamento que exibe este símbolo no produto e/ou na sua embalagem não seja eliminado junto com os resíduos municipais não separados. O símbolo indica que este produto deve ser eliminado separadamente dos resíduos domésticos regulares.
Appendix E Appendix E: Software License Agreement Software in Linksys Products This product from Cisco-Linksys LLC or from one of its affiliates Cisco Systems-Linksys (Asia) Pte Ltd. or CiscoLinksys K.K. (“Linksys”) contains software (including firmware) originating from Linksys and its suppliers and may also contain software from the open source community. Any software originating from Linksys and its suppliers is licensed under the Linksys Software License Agreement contained at Schedule 1 below.
Software License Agreement Appendix E your Linksys product and/or the Software is being used in accordance with the terms of this Agreement; (iii) to provide improvements to the way Linksys delivers technology to you and to other Linksys customers; (iv) to enable Linksys to comply with the terms of any agreements it has with any third parties regarding your Linksys product and/or Software and/or (v) to enable Linksys to comply with all applicable laws and/or regulations, or the requirements of any regulat
Appendix E GNU General Public License is intended to guarantee your freedom to share and change free software–to make sure the software is free for all its users. This General Public License applies to most of the Free Software Foundation’s software and to any other program whose authors commit to using it. (Some other Free Software Foundation software is covered by the GNU Lesser General Public License instead.) You can apply it to your programs, too.
Appendix E c. If the modified program normally reads commands interactively when run, you must cause it, when started running for such interactive use in the most ordinary way, to print or display an announcement including an appropriate copyright notice and a notice that there is no warranty (or else, saying that you provide a warranty) and that users may redistribute the program under these conditions, and telling the user how to view a copy of this License.
Software License Agreement Appendix E 7. If, as a consequence of a court judgment or allegation of patent infringement or for any other reason (not limited to patent issues), conditions are imposed on you (whether by court order, agreement or otherwise) that contradict the conditions of this License, they do not excuse you from the conditions of this License.
Appendix E GNU LESSER GENERAL PUBLIC LICENSE Version 2.1, February 1999 Copyright (C) 1991, 1999 Free Software Foundation, Inc. 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA Everyone is permitted to copy and distribute verbatim copies of this license document, but changing it is not allowed. [This is the first released version of the Lesser GPL. It also counts as the successor of the GNU Library Public License, version 2, hence the version number 2.1.
Appendix E freedom and the wherewithal to run that program using a modified version of the Library. The precise terms and conditions for copying, distribution and modification follow. Pay close attention to the difference between a “work based on the library” and a “work that uses the library”. The former contains code derived from the library, whereas the latter must be combined with the library in order to run.
Appendix E Thus, it is not the intent of this section to claim rights or contest your rights to work written entirely by you; rather, the intent is to exercise the right to control the distribution of derivative or collective works based on the Library. In addition, mere aggregation of another work not based on the Library with the Library (or with a work based on the Library) on a volume of a storage or distribution medium does not bring the other work under the scope of this License. 3.
Appendix E Software License Agreement b) Use a suitable shared library mechanism for linking with the Library. A suitable mechanism is one that (1) uses at run time a copy of the library already present on the user’s computer system, rather than copying library functions into the executable, and (2) will operate properly with a modified version of the library, if the user installs one, as long as the modified version is interface-compatible with the version that the work was made with. 8.
Software License Agreement Appendix E software distributed through that system in reliance on consistent application of that system; it is up to the author/donor to decide if he or she is willing to distribute software through any other system and a licensee cannot impose that choice. This section is intended to make thoroughly clear what is believed to be a consequence of the rest of this License. 12.
Appendix E Software License Agreement OpenSSL License Original SSLeay License Copyright © 1998-2007 The OpenSSL Project. All rights reserved. Copyright © 1995-1998 Eric Young (eay@cryptsoft.com)All rights reserved. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: This package is an SSL implementation written by Eric Young (eay@cryptsoft.com). 1.
Appendix E Software License Agreement DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
