Network Router User Manual

Index
WC-309
Cisco IOS Wide-Area Networking Configuration Guide
LLC/SNAP
ATM
configuration (example)
WC-87
LMI
autosense
WC-117
DCE
polling verification timer
WC-119
DTE
error threshold
WC-119
full status polling interval WC-119
monitored events counter WC-119
Frame Relay WC-117
keepalives WC-119
NNI
error threshold
WC-119
monitored events counter WC-119
polling verification timer WC-119
specifications WC-10
LMI keepalive interval, setting WC-119
LMI statistics, displaying WC-147
LMI type, setting WC-118
LMI type to NVRAM, writing WC-118
load balancing, X.25 (example) WC-274
local acknowledgment
X.25 (example)
WC-283
Local Management Interface
See LMI
See also Frame Relay, LMI
logical IP subnetwork
See LIS
loopback command
WC-49
loopback diagnostic command WC-48
loopback mode
ATM
WC-48
M
map class for the VC, specifying WC-129
map-class frame-relay command WC-122
map group and destination addresses for the SVC,
specifying
WC-122
map-group command WC-121
map group to the subinterface, assigning WC-121
map-list command
addresses
E.164, X.121
WC-122
mapping
SMDS static routes
WC-192
mapping addresses
DLCIs
WC-116
static WC-136
maximum length of LAPF I frame N201, setting WC-123
maximum transmission unit size
See MTU size
M-bit
X.25 more data bit
WC-218
message identifiers
ATM
WC-52
MIB
extensions
WC-114
X.25 LAPB, SNMP extension WC-15
X25 Packet Layer, SNMP extension WC-15
microcode
on the AIP
WC-10
mid command WC-53
mnemonic resolution, X.25 WC-244
mode atm command WC-173, WC-178
modes
See command modes
more data bit
X.25
WC-218
mtu command WC-48
MTU size
ATM
WC-48
multiple logical IP subnetwork (LIS)
configuration (example)
WC-201, WC-202
over SMDS WC-14
SMDS WC-196