BC Cisco IOS Bridging and IBM Networking Configuration Guide DNC Cisco IOS Dial Services Configuration Guide: Network Services DTC Cisco IOS Dial Services Configuration Guide: Terminal Services FC Cisco IOS Configuration Fundamentals Configuration Guide IC Cisco IOS Interface Configuration Guide MC Cisco IOS Multiservice Applications Configuration Guide P1C Cisco IOS IP and IP Routing Configuration Guide P2C Cisco IOS AppleTalk and Novell IPX Configuration Guide P3C Cisco IOS Apollo Domain,
Index X.121, setting AAL3/4 WC-215 X.121 alias, setting enabling WC-221 X.25 interface-based insertion and removal WC-240 Address Resolution Protocol WC-51 encapsulations (example) See ARP WC-51 WC-96 static mapping ADSL termination WC-51 AAL5 PPP over ATM connection configuration (example) WC-71, WC-102 AESA AAL5-SNAP (example) embedded E.
Index description message identifiers WC-2 E.164 addresses E.
Index configuration, bit rates configuring OAM, configuring WC-21 WC-43 traffic parameters, configuring WC-19 configuring (example) WC-87, WC-88 traffic shaping, configuring discovery, configuring WC-22 VC classes, configuring PPP over ATM traffic parameters, configuring VC classes, configuring transmit clock WC-21 configuring vci-to-vpi ratio serial interfaces description limits, configuring WC-83, WC-84 Service Interworking WC-39 WC-46 management, configuring WC-40, WC-41, WC-42,
Index atm maxvc command backup interface for the subinterface, configuring WC-139 WC-50 atm mid-per-vc command WC-53 atm multicast command backup interfaces WC-52 atm multipoint-interval command atm multipoint-signalling command atm nsap-address command atm oam flush command Frame Relay WC-33 Bc, Frame Relay committed burst size WC-33 WC-30, WC-31, WC-32 address conventions (figure) WC-110 interface types translation table WC-3 atm pvp command WC-260 Cisco’s implementation WC-48 atm r
Index bridge-group command cautions usage in text LAPB WC-211 SMDS WC-196 xxiii CCO bridge protocol command LAPB WC-54, WC-138 WC-54 WC-211 bridging accessing xxiii definition xxiii CES ATM ATM transparent channel-associated signaling WC-53 multicast address clear channel SMDS address mapping SMDS WC-192 WC-196 X.
Index Frame Relay See CCO Cisco IOS payload saving configuration changes class command LAPB xxx WC-143 WC-142 WC-207 TCP/IP header WC-127 class-int command WC-40 class-vc command WC-25, WC-36, WC-40 WC-143 X.25 clear frame-relay-inarp command payload WC-147 WC-230 TCP/IP header WC-229 clear x25 command WC-261, WC-266 compress predictor command clear xot command WC-266 condition signaling BECN clock source ATM, configuring WC-80 CMNS address map X.
Index point of presence (POP) POPs, configuring use in LAPB WC-251 X.25 WC-254 encapsulation POP with access restricted to one CUG (example) WC-285 POP with multiple CUGs and public access (example) WC-286 POP with no CUG access (example) (example) X.25 WC-285 WC-214 address conventions (figure) WC-258 address conversion scheme WC-258 WC-286 WC-259 encapsulation types WC-259 IP address conventions (figure) WC-248 mapping algorithm WC-284 standard service custom queueing X.
Index destination address and Frame Relay map class for QoS, specifying WC-123 E destination-pattern command E.164 WC-175 telephone numbering specification dial backup Frame Relay DLCIs E.164 addresses, SMDS WC-138 dial-peer voice command configuring WC-175 WC-52 E.
Index SMDS X.25 flow control parameter behavior WC-191 disabled setting WC-212 X.
Index DCE switch DE bit idle timeout interval, setting WC-140 IETF encapsulation WC-146 DE list, defining (examples) WC-146 device, configuring dial backup dial peer ports (POTS only), enabling dial peer preferences, configuring digit-forwarding, configuring discard eligibility (DE) bit WC-175 WC-175 WC-175 dial peer session targets, configuring WC-176 IP tunnel IP unnumbered (example) WC-151 IPX keepalives WC-146 WC-151 WC-119 end-to-end status mechanism WC-116, WC-136, WC-137 DLC
Index See also Frame Relay, LMI (examples) OAM PVC management, enabling packet discard eligibility payload compression peers, defining WC-178 WC-146 overview WC-150 to WC-152 WC-133 partially meshed networks point-to-point addressing WC-142 split horizon WC-175 point-to-point links (example) WC-152 point-to-point tunnel (example) WC-165 PPP WC-133 WC-135 WC-133 static address mapping transparent bridging WC-137 WC-137 SVCs DCE configuration (example) configuration (examples) configura
Index traffic statistics, displaying transparent bridging (example) configuration tasks WC-147 error event WC-137 UBR+ values, assigning event window WC-174 VBR-RT values, assigning WC-174 Frame Relay-ATM Interworking FRF.
Index frame-relay map command WC-116, WC-137, WC-143 frame-relay map ip cisco tcp header-compression command WC-144 frame-relay map ip no compress command WC-145 frame-relay map payload-compress command FRMR frames at the LAPF Frame Reject procedure, not sending WC-123 G WC-142 global configuration mode frame-relay map payload-compress frf9 stac command WC-143 summary xxvi Frame Relay maps class, specifying clearing WC-122, WC-127 H WC-147 entries, displaying group, assigning HDLC WC-147
Index See ILMI IMA bandwidths WC-67 configuring WC-54 to WC-68 Internet Engineering Task Force (example), E1 WC-97 (example), T1 WC-100 overview International Telecommunication Union Standardization Sector (ITU-T) X.
Index IP address and subnet mask, assigning ip address command SMDS (example) WC-174 task list WC-18, WC-121, WC-174, WC-211 WC-267 WC-206 custom queuing WC-197 IP map for encapsulation and TCP/IP header compression, configuring WC-144 ip route-cache command WC-70, WC-198 ip unnumbered ethernet command WC-210 datagram transport encapsulation WC-207 frame error detection WC-69 WC-206, WC-208 general statistics, displaying IPX modulo, function Frame Relay WC-150, WC-151 N1 parameter mul
Index LLC/SNAP map group and destination addresses for the SVC, specifying WC-122 ATM configuration (example) WC-87 map-group command WC-121 map group to the subinterface, assigning LMI autosense map-list command WC-117 addresses DCE polling verification timer WC-119 E.164, X.
Index multiple parallel DLCIs, enabling O WC-147 multipoint subinterface with a DLCI, associating WC-136 OAM multiprotocol SMDS configuration (example) multiprotocol X.
Index payload compression on a point-to-point interface, enabling WC-142 PDN (example) WC-159 DTE configuration CMNS (example) WC-279 datagram transport (figure) X.25 DCE configuration (example) WC-222 frame format WC-14 WC-131 PVC mapping, defining X.25, configuring WC-214 restrictions permanent virtual circuit WC-132 WC-130 ppp authentication chap command See PVC WC-69 PPP over ATM physical layer interface module Cisco proprietary See PLIM configuring ping WC-72 (example) X.
Index SMDS queueing WC-14, WC-198 (example) effect of X.25 flow control WC-203 public data network X.
Index bridge frame formats enabling WC-53 multiprotocol encapsulation WC-4, WC-82 RFC 1490 HSSI multiprotocol encapsulation WC-110 WC-83 PVCs, ATM-DXI WC-83 RFC 1577 WC-83, WC-84 HDLC encapsulation, default classical IP and ARP over ATM IP and ARP over ATM WC-9 WC-206 Service-Specific Connection-Oriented Protocol managed objects for ATM See SSCOP WC-10 service tcp-keepalives-in command WC-145 ROM monitor mode summary session target command show arp command WC-156 routing WC-85,
Index show smds traffic command show sscop command address mapping WC-85 show x25 interface command show x25 map command WC-266 WC-245, WC-266 show x25 services command WC-18, WC-70 ATM WC-14, WC-197 WC-13, WC-194 enabling, task overview WC-191 WC-191 fast switching WC-198 transparent bridging WC-196 hardware requirements WC-189 IP point-to-multipoint, configuring SIG-TS-001/1991 standard WC-32 address mapping configuring WC-197 SMDS WC-193 WC-195 fast switching address WC-198
Index SDSU equipment description WC-13 standards, defining static map entries keepalive timer WC-13 configuring WC-192 static routing table WC-190 configuring WC-37 receiver windows configuring transparent bridging WC-13 WC-38 transmitter windows VINES configuring address mapping configuring WC-192 WC-38 sscop cc-timer command WC-196 sscop max-cc command address mapping configuring WC-193 smds dxi command WC-37 sscop receive-window command WC-191, WC-197 WC-197 WC-193, WC-194,
Index X.25 TCP configuring connections WC-223 deleting and reestablishing (example) WC-272 multipoint WC-223 point-to-point X.
Index multiprotocol LAPB (example) WC-211 vci-to-vpi ratio ATM WC-268 WC-51 Frame Relay WC-10 VC packet hold queue size, defining (example) WC-152 VCs SMDS ATM WC-13, WC-196 classes, configuring troubleshooting ATM WC-233 WC-38, WC-39 management, configuring WC-84 WC-40, WC-41, WC-42, WC-43 Tymnet X.
Index ATM booting from a network server (example) WC-2 chapter description bridging WC-1 WC-229 IP and ARP WC-9 bridging frames, enabling organization WC-1 bridging on wide-area networking See WANs bundling X.25 and LAPB commands WC-246 calling address insertion and removal WC-240 WC-276 Call Request packet WC-222 Cisco’s implementation X.
Index CUG service, subscribing custom queuing load balancing (example) WC-253 local acknowledgment (example) WC-248 datagram transport (figure) D-bit WC-223 WC-14 locally switched PVC WC-237 map usage, restricting WC-234 M-bit WC-222 DCE encapsulation DDN network user ID (Cisco) address conventions (figure) OSPF, broadcasts outgoing calls from a map, restricting WC-286 WC-259 over ISDN mapping algorithm WC-257 over TCP/IP (XOT) type of service (TOS) field DNS-based routing (exampl
Index remote tunneling (example) switching (example) QLLC over timers WC-273 tunneling WC-270, WC-273 received keepalives, enabling remote failure detection accept reverse charging WC-261 configuration task list WC-233 list of configuration task list transit delay WC-227 clearing multiprotocol WC-242 WC-231 WC-225 options available positional parameters security, POPs WC-248 sent keepalives, enabling services, displaying WC-235 encapsulation WC-225 identification WC-225 (table)
Index X.25 over Frame Relay (Annex G) X.25 profiles WC-246 applying to a line WC-246 X.28 mnemonics creating WC-243 X.29 x25 address command WC-242 x25 alias command (figure) virtual circuits, displaying WC-245 See also LAPB WC-241 WC-219 flow control parameter negotiation WC-216 WC-216 WC-246 X.
Index x25 map no-outcoming command x25 map nudata command x25 map nuid command WC-233 WC-233 x25 map nvc command x25 map pad command x25 t23 command WC-220 WC-218 WC-265 WC-266 XNS WC-233 multicast address, SMDS address mapping WC-233 SMDS, configuring WC-232 WC-195 XOT WC-214 x25 nvc command WC-231 destination x25 ops command WC-218 keepalive options x25 pad-access command WC-221 WC-218 x29 profile command x25 map transit-delay command x25 modulo command WC-220 x29 access-list
