Universal Broadband Router Hardware Installation Guide

Index
IN-10
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01
connector pinout 10BASE-T (table) B-6
crossover cable identification (figure) B-5
plug and receptacle (figure) B-2
rollover cable identification(figure) B-3
straight-through cable identification(figure) B-6
RJ-45-to-DB-9 console cable adapter (figure) 3-50
rollover cable B-2
routing the AC power cables (figure) 3-38, 5-25
S
safety guidelines 2-1
electricity 2-3
lifting the chassis 2-2
preventing electrostatic discharge damage 2-2
translated warnings 1-xiv
SECAM
frequency allocation C-14
standard, description C-1
setting AC power switch to the ON position (figure) 5-26
setting DC power switch to the on position (figure) 5-13
setup command 3-65
setup facility 3-62
SFP module
inserting 5-58
removing 5-56
types 5-56
SFP modules 5-56
show environment command 2-5, 4-12
show facility-alarm status command 4-3
show int fast0/0 command 4-4
simplex SC cable connector (figure) B-9
simplex SC-type cable and connector (figure) 1-47
site requirements 2-4
environmental 2-5, 2-6
equipment racks 2-10
plant wiring 2-8
slot numbering 1-11
slot splitter
installing 3-42
removing 3-12, 3-15
software
Cisco uBR10012 router 1-7
configuration setup 3-63
LCD display panel 1-14
system configuration dialog 3-63
specifications
airflow A-1
altitude A-1
DC PEM A-2
GBIC 1-37
gigabit Ethernet line card A-6
humidity A-1
operating conditions 2-7
PRE module A-4
specifications for operating and nonoperating
environments (table)
2-6
spectrum analyzer manufacturers D-2, D-4
splitter manufacturers D-1, D-3
startup troubleshooting 4-6
straight-through cables B-5, B-6
stripping insulation (figure) 3-29, 3-32, 5-19
subnet mask 3-65
subsystems for troubleshooting
cooling 4-2, 4-11
power 4-2, 4-8
processor 4-2
system
configuration dialog 3-63
power on 3-60
shutdown 5-2
T
tables
tools and supplies for connecting DC power 3-29,
3-32, 3-34, 3-49