Universal Broadband Router Hardware Installation Guide

Index
IN-7
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01
front cover (figure) 5-4
lifting chassis 2-2
optional cable management brackets (figure) 3-21
PRE module 5-28
preparing for 2-10
site requirements 2-4
interference, radio frequency 2-8
IOS command line interface, see CLI
IP
address 4-5
router address 3-62
routing command 3-65
subnet mask 3-65
J
Japan
frequency allocations C-8, C-10
Japanese channel assignments (table) C-8
L
laser warning 1-36, 1-38, 1-41, 1-42, 3-55, 5-39
LCD
cable (figure) 1-15
display panel description 1-14
module display (figure) 1-14
LCP2, see Cisco uBR10-LCP2-MC16C/E/S interface line
card
LCP2, see Cisco uBR10-LCP2-MC28C interface line card
LEDs
cable interface line cards 5-64
Cisco uBR10-LCP2-MC28C 1-34
Cisco uBR-MC28C 1-34
DC PEM 1-22, 4-7, 4-8, 5-9, 5-15
enabled 4-6, 4-12
fan assembly module 1-13
fan failure 4-4
fault 4-3
LNK 4-4
major, minor, critical 4-3
miswire 3-60, 4-3, 5-9, 5-15
network uplink line cards 5-44
OC-12 POS 1-42
PC media card slot 4-6
power 3-61, 4-3
PRE module 1-19
TCC+ card 1-27
line card captive screw locations (figure) 3-11, 5-40, 5-61
Line card processor, see Cisco uBR10-LCP2-MC16C/E/S
interface line card
Line card processor, see Cisco uBR10-LCP2-MC28C
interface line card
line cards
blank covers for cable interface line cards 5-62
blank slot covers for network uplink line cards 5-43
Cisco uBR10-LCP2-MC16C/E/S description 1-28
Cisco uBR10-LCP2-MC28C description 1-32
Cisco uBR-MC28C 1-32
configuring 5-45
Gigabit Ethernet 1-36
gigabit Ethernet 1-37, 3-56
hot-swapping 5-39
initialization 3-61
OC-12 POS 1-41
power-on self-test 5-44, 5-64
removing 3-10, 5-60
replacing 3-39, 5-60
shutting down 5-39, 5-60
list of fru guides with URLs (table) 1-50
list of fru modules and order numbers 1-48
lithium battery on PRE 1-20
locating
captive screws on the PRE1 module (figure) 5-29
DC power connectors (figure) 3-30
ground lug connectors (figure) 3-27
loss of service 5-26