Universal Broadband Router Hardware Installation Guide

1-7

Cisco uBR10012 Universal Broadband Router Hardware Installation Guide

OL-18259-01

Chapter 1 Cisco uBR10012 Universal Broadband Router Overview

NEBS Level 3 Compliance

The Cisco uBR10012 router is Network Equipment Building System (NEBS) Level 3 compliant. This

includes the following categories:

• Filtration and front to back airflow

• Transportation and storage

• Operating temperature and humidity

• Heat dissipation and fire spread

• Packaged equipment shock

• Earthquake, office, and transportation vibration

• Airborne contaminants and acoustic noise

• Lightning immunity

• Electrical safety

• EMI emissions and immunity

Cisco uBR10012 Universal Broadband Router Hardware

This section describes the Cisco uBR10012 router and router components.

Cisco uBR10012 Router

The Cisco uBR10012 router is installed in a standard 19-inch equipment or telco rack. A rack-mount kit

ships from the Cisco

factory with each router. The rack-mount kit includes the hardware needed to mount

the router in a standard 19-inch equipment rack or telco-type rack. Mounting in 23-inch equipment racks

is possible with optional third-party mounting hardware.

The Cisco uBR10012 chassis is designed for front and rear access. The two AC or DC PEMs, two PREs,

the LCD panel, and the fan assembly module are accessed from the front of the chassis, see

Figure 1-2.

The eight slots for cable interface line cards, four full-slots for network uplink line cards, and two slots

for the TCC+ cards are accessed from the rear of the chassis, see

Figure 1-3.

Note The Cisco uBR10012 router uses an auxiliary 2400 WAC-input power shelf for situations where 100-120

VAC is the only available power source. The AC-input power shelf converts AC to DC for the router. For

more information about the power shelf, refer to 2400W AC-Input Power Shelf for the Cisco uBR10012

Universal Broadband Router at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ubr10012/frus/index.htm

Figure 1-1 shows the front of the Cisco uBR10012 router with the front cover installed.