Universal Broadband Router Hardware Installation Guide

5-68
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01
Chapter 5 Maintaining the Cisco uBR10012 Router
Removing and Replacing the Cable Interface Line Card in the Adapter Card
Installing a Cable Interface Line Card in the Adapter Card
Step 1 Using the handle on the new or replacement Cisco MCxx card, align the holes in the L-brackets with the
screws on the adapter card.See
Figure 5-59.
Step 2 Align the Cisco MCxx card with the guide rails in the Cisco uBR10-LCP2 adapter card, and ensure that
the Cisco MCxx card’s sheet metal is flush with the sheet metal on the bottom of the adapter card (the
Cisco
MCxx card should slide under the spring guides and not over them).
Step 3 Slide the Cisco MCxx card into the Cisco uBR10-LCP2 adapter card slowly, making sure that the
Cisco
MCxx card is sliding under the spring guides. Also verify that its power connectors are aligned
with those on the adapter card. Continue slowly pushing until the connectors on the Cisco
MCxx card
are firmly connected to the connectors on the adapter card. The ejector levers on each side of the card
should snap into place when the card is fully inserted.
Note Make sure that the screws on the adapter card brackets slide cleanly into the holes in the
L-brackets. These brackets help to align the adapter card and cable interface line card connectors
and hold the cable interface line card in place.
Step 4 Tighten the captive screws on the Cisco MCxx card to secure it to the Cisco uBR10-LCP2 adapter card.
Step 5 Reattach the retaining washers and screws on the L-brackets on the Cisco MCxx card. Make sure they
are finger-tight, and then turn them a half-turn with a wrench to secure them and the card in place.
Step 6 Reinsert the Cisco uBR10-LCP2-MCxx cable interface line card, as described in the “Removing and
Replacing a Cable Interface Line Card” section on page 5-60.
Step 7 Connect all downstream and upstream coaxial cables to the cable interface line card as necessary.
Step 8 Configure the cable interface line card if necessary (see the Cisco uBR10012 Software Configuration
Guide for information about configuring the line card).
Note It is not necessary to configure the cable interface line card if you are installing a replacement card in
the same slot. The system automatically downloads the necessary configuration information from the
PRE.