Universal Broadband Router Hardware Installation Guide

5-45
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01
Chapter 5 Maintaining the Cisco uBR10012 Router
Removing the Half-Height Gigabit Ethernet Line Card and the Slot Splitter
Step 7 Configure the network line card if necessary (see the “Formatting PC Media Cards” section on
page 3-66, or refer to the Cisco uBR10012 Router Software Configuration Guide, for information about
configuring the card).
Note It is not necessary to configure the network card if you are installing a replacement card in the
same slot. The system automatically downloads the necessary configuration information from
the PRE module.
Removing the Half-Height Gigabit Ethernet Line Card and the
Slot Splitter
This section describes how to properly remove and replace HHGE line cards and the slot splitter from
the chassis. This section includes the following tasks:
• Removing a Half-Height Gigabit Ethernet Line Card, page 5-45
• Removing the Slot Splitter, page 5-48
Removing a Half-Height Gigabit Ethernet Line Card
Use the following procedure to remove the HHGE line card from the slot splitter:
Step 1 Verify that you are properly grounded.
Step 2 Disconnect any network cables connected to the line card port.