Universal Broadband Router Hardware Installation Guide

5-39
Cisco uBR10012 Universal Broadband Router Hardware Installation Guide
OL-18259-01
Chapter 5 Maintaining the Cisco uBR10012 Router
Removing and Replacing a Network Line Card
Removing and Replacing a Network Line Card
Use the following procedure to install a new network line card, or to remove or replace an existing
network line card in the Cisco uBR10012 chassis. The following cards are supported:
• Cisco OC-12/STS12c/STM4 POS (UBR10-OC12/P-SMI=)
• Cisco uBR10-SRP-OC12SML-DPT WAN (UBR10-SRP-OC12SML=)
• Cisco Single Port Gigabit Ethernet line card (UBR10-1GE=)
• Cisco uBR10012 OC-48 DPT/POS interface module
Tip To prevent alarms from activating, you can administratively shut down a line card before hot-swapping
it. Otherwise, inform the network administrator that this portion of the network will be temporarily
interrupted.
Removing the Network Line Card
Warning Class 1 laser product. Statement 1008
Warning Invisible laser radiation present. Statement 1016
Warning Because invisible radiation may be emitted from the aperture of the port when no fiber cable is
connected, avoid exposure to radiation and do not stare into open apertures. Statement 1056
Warning Statement for Sweden
Warning Osynlig laserstrålning när denna del är öppen och förregleringen är urkopplad. Rikta inte blicken in
mot strålen. Statement 1036
Warning Statement for Finland
Warning Alleviates ja suojalukitus ohitettaessa olet alttiina näkymättömälle lasersäteilylle. Äjä katso
säteeseen. Statement 1035
Step 1 Attach an antistatic wrist strap to your wrist and to a bare metal surface on the chassis or frame.
Step 2 Face the back of the Cisco uBR10012 chassis. Clear aside enough interface and power cables to allow
sufficient space to work.