User's Manual

Procedure
PurposeCommand or Action
Enters the CIMC command mode.Server# scope cimc
Step 1
Enters the CIMC network command mode.Server /cimc # scope network
Step 2
Specifies the port profile CIMC should use to configure the
management interface, the virtual Ethernet, and the VIF on
Server /cimc/network # set
port-profile port_profile_name
Step 3
supported adapter cards such as the Cisco UCS VIC1225
Virtual Interface Card.
Enter up to 80 alphanumeric characters. You cannot use
spaces or other special characters except for - (hyphen) and
_ (underscore). In addition, the port profile name cannot begin
with a hyphen.
The port profile must be defined on the switch to
which this server is connected.
Note
Commits the transaction to the system configuration.Server /cimc/network # commit
Step 4
(Optional)
Displays the network settings.
Server /cimc/network # show
[detail]
Step 5
This example connects to port profile abcde12345:
Server# scope cimc
Server /cimc # scope network
Server /cimc/network # set port-profile abcde12345
Server /cimc/network *# commit
Server /cimc/network # show detail
Network Setting:
IPv4 Address: 10.193.66.174
IPv4 Netmask: 255.255.248.0
IPv4 Gateway: 10.193.64.1
DHCP Enabled: no
Obtain DNS Server by DHCP: no
Preferred DNS: 0.0.0.0
Alternate DNS: 0.0.0.0
VLAN Enabled: no
VLAN ID: 1
VLAN Priority: 0
Port Profile: abcde12345
Hostname: Server
MAC Address: 50:3D:E5:9D:63:3C
NIC Mode: dedicated
NIC Redundancy: none
Server /cimc/network #
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 79
Configuring Network-Related Settings
Connecting to a Port Profile