User's Manual

PurposeCommand or Action
• Cisco card—The ports on the adapter card are used to access
the CIMC.
Sets the NIC redundancy mode when the NIC mode is Shared
LOM. The redundancy mode can be one of the following:
Server /cimc/network # set
redundancy {none |
Step 4
active-active |
active-standby}
• none—The LOM Ethernet ports operate independently and
do not fail over if there is a problem.
• active-active—If supported, all LOM Ethernet ports are
utilized.
• active-standby—If one LOM Ethernet port fails, traffic fails
over to another LOM port.
Commits the transaction to the system configuration.Server /cimc/network #
commit
Step 5
The available NIC mode and NIC redundancy mode
options may vary depending on your platform. If you
select a mode not supported by your server, an error
message displays when you save your changes.
Note
This example configures the CIMC network interface:
Server# scope cimc
Server /cimc # scope network
Server /cimc/network # set mode dedicated
Server /cimc/network *# commit
Server /cimc/network #
Configuring Common Properties
Use common properties to describe your server.
Before You Begin
You must log in as a user with admin privileges to configure common properties.
Procedure
PurposeCommand or Action
Enters the CIMC command mode.Server# scope cimc
Step 1
Enters the CIMC network command mode.Server /cimc # scope network
Step 2
Specifies the name of the host.Server /cimc/network # set hostname
host-name
Step 3
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 75
Configuring Network-Related Settings
Configuring Common Properties