User's Manual

Procedure
PurposeCommand or Action
Enters the virtual media command mode.Server # scope vmedia
Step 1
Specifies the volume name to unmap.
Server /vmedia # unmap volume_name
Step 2
This example shows how to unmap a local vmedia volume:
Server # scope vmedia
Server /vmedia # show mappings
Volume Map-status Drive-type remote-share remote-file mount-type
------ ---------- ------------ --------------------- ------------------- -----------
Huu OK removable http://10.104.236.99/ rhel-server-6.1-x86_6.iso www
Rhel OK CD http://10.104.236.99/ rhel-server-6.1-x86_6.iso www
Server /vmedia # unmap huu
Server /vmedia # show mappings
Volume Map-status Drive-type remote-share remote-file mount-type
------ ---------- ------------ --------------------- ------------------- -----------
Rhel OK CD http://10.104.236.99/ rhel-server-6.1-x86_6.iso www
Server /vmedia #
Managing Serial over LAN
Serial Over LAN
Serial over LAN (SoL) is a mechanism that enables the input and output of the serial port of a managed system
to be redirected via an SSH session over IP. SoL provides a means of reaching the host console via CIMC.
Guidelines and Restrictions for Serial Over LAN
For redirection to SoL, the server console must have the following configuration:
•
console redirection to serial port A
•
no flow control
•
baud rate the same as configured for SoL
•
VT-100 terminal type
•
legacy OS redirection disabled
The SoL session will display line-oriented information such as boot messages, and character-oriented screen
menus such as BIOS setup menus. If the server boots an operating system or application with a bitmap-oriented
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 61
Managing Remote Presence
Managing Serial over LAN