User's Manual

PurposeCommand or Action
This example enables low voltage DDR memory mode and commits the transaction:
Server# scope bios
Server /bios # scope advanced
Server /bios/advanced # set LvDDRMode Enabled
Server /bios/advanced *# commit
Changes to BIOS set-up parameters will require a reboot.
Do you want to reboot the system?[y|N] n
Changes will be applied on next reboot.
Server /bios/advanced #
Configuring Server Management BIOS Settings
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the BIOS command mode.Server# scope bios
Step 1
Enters the server management BIOS settings command mode.Server /bios # scope
server-management
Step 2
The BIOS parameters available depend on the model of the server
that you are using. For descriptions and information about the
options for each BIOS setting, see one the following topics:
Configure the BIOS settings.
Step 3
•
Server Management BIOS Parameters for C22 and C24
Servers , on page 200
•
Server Management BIOS Parameters for C200 and C210
Servers
•
Server Management BIOS Parameters for C250 Servers
•
Server Management BIOS Parameters for C260 Servers , on
page 232
•
Server Management BIOS Parameters for C460 Servers , on
page 263
Commits the transaction to the system configuration.Server
/bios/server-management #
commit
Step 4
Changes are applied on the next server reboot. If server power is
on, you are prompted to choose whether to reboot now.
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 33
Managing the Server
Configuring Server Management BIOS Settings