User's Manual

•
The card read/write error counts and read/write threshold are set to 0.
•
Host connectivity could be disrupted.
Before You Begin
•
You must log in with admin privileges to perform this task.
•
Cisco Flexible Flash must be supported on your server.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters the Cisco Flexible Flash controller command
mode for the specified controller. At this time, the
only permissible index value is FlexFlash-0.
Server /chassis # scope flexflash index
Step 2
Resets the configuration of the selected slot to the
default configuration.
Server /chassis/flexflash # reset-config
primary slot ID
Step 3
Commits the transaction to the system configuration.Server /chassis/flexflash # commit
Step 4
This example shows how to reset the configuration from a slot to the default configuration:
Server# scope chassis
Server /chassis # scope flexflash FlexFlash-0
Server /chassis/flexflash # reset-config slot1
This action will mark the slot1 as the healthy primary slot, and slot2 (if card exists)
as unhealthy secondary active.
This operation may disturb the host connectivity as well.
Continue? [y|N] y
Server /chassis/flexflash/operational-profile *# commit
Server /chassis/flexflash/operational-profile #
Retaining the Configuration of the Flexible Flash Controller
You can copy the configuration of a given slot in the Cisco Flexible Flash card to the other slot. However,
the slot from which the configuration is copied from must be of the SDK523 type. You can retain the
configuration in the following situations:
•
There are two unpaired SD cards
•
The server is operating from a single SD card, and an unpaired SD card is in the other slot.
•
One SD card supports firmware version 1.2.253, and the other SD card is either unpartitioned or supports
firmware version 1.2.247.
Before You Begin
•
You must log in with admin privileges to perform this task.
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 29
Managing the Server
Retaining the Configuration of the Flexible Flash Controller