User's Manual

PurposeCommand or Action
Currently, Cisco Flexible Flash cards are
supported in slot 1 and slot 2. Therefore, you
can specify slot1 or slot2.
Important
# set raid-primary-member {slot1
| slot2}
The role of the secondary RAID. The currently supported
value is active.
Server
/chassis/flexflash/operational-profile
# set raid-secondary-role {active |
initializing}
Step 5
Specifies the number of read errors that are permitted while
accessing the Cisco Flexible Flash card. If the number of
Server
/chassis/flexflash/operational-profile
# set read-error-count-threshold
Step 6
errors exceeds this threshold, the Cisco Flexible Flash card
is disabled and you must reset it manually before CIMC
attempts to access it again.
To specify a read error threshold, enter an integer between
1 and 255. To specify that the card should never be disabled
regardless of the number of errors encountered, enter 0 (zero).
Specifies the number of write errors that are permitted while
accessing the Cisco Flexible Flash card. If the number of
Server
/chassis/flexflash/operational-profile
# set write-error-count-threshold
Step 7
errors exceeds this threshold, the Cisco Flexible Flash card
is disabled and you must reset it manually before CIMC
attempts to access it again.
To specify a write error threshold, enter an integer between
1 and 255. To specify that the card should never be disabled
regardless of the number of errors encountered, enter 0 (zero).
Specifies a list of virtual drives to be made available to the
server as a USB-style drive. The options are as follows:
Server
/chassis/flexflash/operational-profile
# set virtual-drives-enabled list
Step 8
• SCU—The server can access the Cisco UCS Server
Configuration Utility.
• DRIVERS—The server can access the Cisco drivers
volume.
• HV—The server can access a user-installed hypervisor.
• HUU—The server can access the Cisco Host Upgrade
Utility.
When specifying more than one option, you must enclose
the list in quotation marks (").
Commits the transaction to the system configuration.Server /chassis/adapter # commit
Step 9
This example shows how to configure the properties of the Flash controller:
Server# scope chassis
Server /chassis # scope flexflash FlexFlash-0
Server /chassis/flexflash # scope operational-profile
Server /chassis/flexflash/operational-profile # set read-error-count-threshold 100
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
26 OL-28893-01
Managing the Server
Configuring the Flexible Flash Controller Properties