User's Manual

Description: Testing power restore
Power Restore Policy: power-on
Power Delay Type: fixed
Power Delay Value(sec): 180
Server /chassis #
Managing the Flexible Flash Controller
Cisco Flexible Flash
Some C-Series Rack-Mount Servers support an internal Secure Digital (SD) memory card for storage of server
software tools and utilities. The SD card is hosted by the Cisco Flexible Flash storage adapter.
The SD storage is available to CIMC as four virtual USB drives. Three are preloaded with Cisco software
and the fourth can hold a user-installed hypervisor or other content. The four virtual drives are as follows:
•
Cisco UCS Server Configuration Utility (bootable)
•
User-installed (may be bootable)
•
Cisco drivers (not bootable)
•
Cisco Host Upgrade Utility (bootable)
For information about the Cisco software utilities and packages, see the Cisco UCS C-Series Servers
Documentation Roadmap at this URL:
http://www.cisco.com/go/unifiedcomputing/c-series-doc
Dual Card Management in the Cisco Flexible Flash Controller
The Cisco Flexible Flash controller supports management of two SD cards as a RAID-1 pair. With the
introduction of dual card management, you can perform the following tasks:
DescriptionAction
Allows you to reset the controller.Reset Cisco Flex Flash
Allows you to reset the configuration in the selected
slot to the default configuration.
Reset Configuration
Allows you to retain the configuration for an SD card
that supports firmware version 1.2.253.
Retain Configuration
Allows you to configure the SD cards on the selected
Cisco Flexible Flash controller.
Configure Operational Profile
RAID Partition Enumeration
Non-RAID partitions are always enumerated from the primary card and the enumeration does not depend on
the status of the primary card.
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
24 OL-28893-01
Managing the Server
Managing the Flexible Flash Controller