User's Manual
DescriptionName
Whether a handshake protocol is used for flow control. Request to Send
/ Clear to Send (RTS/CTS) helps to reduce frame collisions that can be
introduced by a hidden terminal problem. This can be one of the
following:
• None—No flow control is used.
• —RTS/CTS is used for flow control.
This setting must match the setting on the remote terminal
application.
Note
Flow Control
Allows you to change the action of the PuTTY function keys and the
top row of the numeric keypad. This can be one of the following:
• VT100—The function keys generate ESC OP through ESC O[.
• LINUX—Mimics the Linux virtual console. Function keys F6 to
F12 behave like the default mode, but F1 to F5 generate ESC [[A
through ESC [[E.
• XTERMR6—Function keys F5 to F12 behave like the default
mode. Function keys F1 to F4 generate ESC OP through ESC
OS, which are the sequences produced by the top row of the
keypad on Digital terminals.
• SCO—The function keys F1 to F12 generate ESC [M through
ESC [X. The function and shift keys generate ESC [Y through
ESC [j. The control and function keys generate ESC [k through
ESC [v. The shift, control and function keys generate ESC [w
through ESC [{.
• ESCN—The default mode. The function keys match the general
behavior of Digital terminals. The function keys generate
sequences such as ESC [11~ and ESC [12~.
• VT400—The function keys behave like the default mode. The top
row of the numeric keypad generates ESC OP through ESC OS.
Putty KeyPad
Whether BIOS console redirection should be active after BIOS POST
is complete and control given to the OS bootloader. This can be one of
the following:
• —BIOS Legacy console redirection is active during the OS boot
and run time.
• Bootloader—BIOS Legacy console redirection is disabled before
giving control to the OS boot loader.
Redirection After BIOS POST
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
198 OL-28893-01
BIOS Parameters by Server Model
Advanced BIOS Parameters for C22 and C24 Servers