User's Manual

If you start an update while an update is already in process, both updates will fail.Note
Procedure
PurposeCommand or Action
Enters the CIMC command mode.Server# scope cimc
Step 1
Enters the CIMC firmware command mode.Server /cimc # scope firmware
Step 2
Specifies the protocol, IP address of the remote server
and the file path to the firmware file on the server. The
protocol can be one of the following:
Server /cimc/firmware # update
protocol IP Address path
Step 3
•
TFTP
•
FTP
•
SFTP
•
SCP
•
HTTP
(Optional)
Displays the progress of the firmware update.
Server /cimc/firmware # show detail
Step 4
This example updates the CIMC firmware:
Server# scope cimc
Server /cimc # scope firmware
Server /cimc/firmware # update ftp 192.0.20.34 //test/dnld-ucs-k9-bundle.1.0.2h.bin
<CR> Press Enter key
Firmware update has started.
Please check the status using "show detail"
Server /cimc/firmware #
What to Do Next
Activate the new firmware.
Activating Installed CIMC Firmware
Before You Begin
Install the CIMC firmware on the server.
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
160 OL-28893-01
CIMC Firmware Management
Activating Installed CIMC Firmware