User's Manual

PurposeCommand or Action
Sets the number of seconds to wait between HTTP
requests before the CIMC times out and terminates the
session.
Server /http # set timeout seconds
Step 6
Enter an integer between 60 and 10,800. The default is
1,800 seconds.
Commits the transaction to the system configuration.Server /http # commit
Step 7
This example configures HTTP for the CIMC:
Server# scope http
Server /http # set enabled yes
Server /http *# set http-port 80
Server /http *# set https-port 443
Server /http *# set http-redirect yes
Server /http *# set timeout 1800
Server /http *# commit
Server /http # show
HTTP Port HTTPS Port Timeout Active Sessions Enabled HTTP Redirected
---------- ---------- -------- --------------- ------- ----------------
80 443 1800 0 yes yes
Server /http #
Configuring SSH
Before You Begin
You must log in as a user with admin privileges to configure SSH.
Procedure
PurposeCommand or Action
Enters the SSH command mode.Server# scope ssh
Step 1
Enables or disables SSH on the CIMC.Server /ssh # set enabled {yes | no}
Step 2
Sets the port to use for secure shell access. The default
is 22.
Server /ssh # set ssh-port number
Step 3
Sets the number of seconds to wait before the system
considers an SSH request to have timed out.
Server /ssh # set timeout seconds
Step 4
Enter an integer between 60 and 10,800. The default
is 300 seconds.
Commits the transaction to the system configuration.Server /ssh # commit
Step 5
(Optional) Displays the SSH configuration.Server /ssh # show [detail]
Step 6
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
134 OL-28893-01
Configuring Communication Services
Configuring SSH