User's Manual

CHAPTER 10
Configuring Communication Services
This chapter includes the following sections:
•
Configuring HTTP, page 133
•
Configuring SSH, page 134
•
Configuring XML API, page 135
•
Configuring IPMI, page 136
•
Configuring SNMP, page 137
Configuring HTTP
Before You Begin
You must log in as a user with admin privileges to configure HTTP.
Procedure
PurposeCommand or Action
Enters the HTTP command mode.Server# scope http
Step 1
Enables or disables HTTP and HTTPS service on the
CIMC.
Server /http # set enabled {yes | no}
Step 2
Sets the port to use for HTTP communication. The
default is 80.
Server /http # set http-port number
Step 3
Sets the port to use for HTTPS communication. The
default is 443.
Server /http # set https-port number
Step 4
Enables or disables the redirection of an HTTP request
to HTTPS.
Server /http # set http-redirect {yes
| no}
Step 5
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 133