User's Manual

Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed
storage card.
Server /chassis # scope storageadapter slot
Step 2
Enters command mode for the specified
physical drive.
Server /chassis/storageadapter # scope
physical-drive drive-number
Step 3
Server /chassis/storageadapter/physical-drive #
prepare-for-removal
Step 4
This example shows how to prepare physical drive 3 for removal.
Server# scope chassis
Server /chassis # scope storageadapter SLOT-3
Server /chassis/storageadapter # scope physical-drive 3
Server /chassis/storageadapter/physical-drive # prepare-for-removal
Server /chassis/storageadapter/physical-drive #
Removing a Drive from Hot Spare Pools
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed
storage card.
Server /chassis # scope storageadapter slot
Step 2
Enters command mode for the specified
physical drive.
Server /chassis/storageadapter # scope
physical-drive drive-number
Step 3
Removes a drive from the host spare pool.Server /chassis/storageadapter/physical-drive
# remove-hot-spare
Step 4
This example shows how to remove physical drive 3 from the hot spare pools:
Server# scope chassis
Server /chassis # scope storageadapter SLOT-3
Server /chassis/storageadapter # scope physical-drive 3
Server /chassis/storageadapter/physical-drive # remove-hot-spare
Server /chassis/storageadapter/physical-drive #
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 123
Managing Network Adapters
Removing a Drive from Hot Spare Pools