User's Manual

PurposeCommand or Action
You are prompted to confirm the action. Enter yes
to confirm.
Server /chassis/storageadapter #
clear-foreign-config
Step 3
If you do not enter yes, the action is
aborted.
Note
This example shows how to clear all foreign configurations on the MegaRAID controller in slot 3:
Server# scope chassis
Server /chassis # scope storageadapter SLOT-3
Server /chassis/storageadapter # clear-foreign-config
Are you sure you want to clear all foreign configurations on this controller?
All data on the drive(s) will be lost.
Enter 'yes' to confirm -> yes
Server /chassis/storageadapter #
Deleting a Virtual Drive
This task deletes a virtual drive, including the drives that run the booted operating system. So back up any
data that you want to retain before you delete a virtual drive.
Important
Before You Begin
You must log in with admin privileges to perform this task.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters command mode for an installed storage
card.
Server /chassis # scope storageadapter slot
Step 2
Enters command mode for the specified virtual
drive.
Server /chassis/storageadapter # scope
virtual-drive drive-number
Step 3
You are prompted to confirm the action. Enter
yes to confirm.
Server /chassis/storageadapter/virtual-drive
# delete-virtual-drive
Step 4
If you do not enter yes, the action is
aborted.
Note
This example shows how to delete virtual drive 3.
Server# scope chassis
Server /chassis # scope storageadapter SLOT-3
Server /chassis/storageadapter # scope virtual-drive 3
Server /chassis/storageadapter/virtual-drive # delete-virtual-drive
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
118 OL-28893-01
Managing Network Adapters
Deleting a Virtual Drive