User's Manual

DescriptionName
The uplink port associated with this VM FEX. All traffic for this VM
FEX goes through this uplink port.
Uplink Port
The MAC address associated with the VM FEX.MAC Address
The class of service to associate with traffic from this VM FEX.Class of Service
Whether the VM FEX can use the class of service provided by the host
operating system.
Trust Host CoS
The order in which this VM FEX will be used.PCI Order
The default VLAN for this VM FEX.Default VLAN
Whether VLAN trunking or access is configured.VLAN Mode
If rate limiting is configured, the maximum rate.Rate Limit
Whether the VM FEX can be used to perform a PXE boot.Enable PXE Boot
If NIV mode is enabled for the adapter, the channel number assigned
to this VM FEX.
Channel Number
If NIV mode is enabled for the adapter, the port profile associated with
theVM FEX.
This field displays the port profiles defined on the switch to
which this server is connected.
Note
Port Profile
If NIV mode is enabled for the adapter, whether traffic on this VM FEX
should fail over to the secondary interface if there are communication
problems.
Enable Uplink Failover
After a VM FEX has started using its secondary interface, this setting
controls how long the primary interface must be available before the
system resumes using the primary interface for the VM FEX.
Failback Timeout
Ethernet Interrupt Settings
DescriptionName
The number of interrupt resources allocated to this VM FEX.Interrupt Count field
The time CIMC waits between interrupts or the idle period that must
be encountered before an interrupt is sent.
Coalescing Time field
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
112 OL-28893-01
Managing Network Adapters
VM FEX Settings