User's Manual

This example displays the VM FEX properties:
Server /chassis/adapter # show vmfex detail
Name pts0:
MTU: 1500
Uplink Port: 0
MAC Address: 00:00:00:00:00:00
CoS: N/A
Trust Host CoS:
PCI Order:
VLAN: N/A
VLAN Mode: N/A
Rate Limiting:
PXE Boot: disabled
Channel Number: 0
Port Profile:
Uplink Failover: Enabled
Uplink Failback Timeout: 5
Server /chassis/adapter # scope vmfex pts0
Server /chassis/adapter/vmfex # show interrupt
Interrupt Count Coalescing Time (us) Coalescing Type Interrupt Mode
--------------- -------------------- --------------- ---------------
6 125 MIN MSI
Server /chassis/adapter/vmfex # show recv-queue
Receive Queue Count Receive Queue Ring Size
------------------- ------------------------------
4 512
Server /chassis/adapter/vmfex # show trans-queue
Transmit Queue Count Transmit Queue Ring Size
-------------------- -------------------------------
1 256
Server /chassis/adapter/vmfex # show comp-queue
Completion Queue Count Completion Queue Ring Size
------------------------- --------------------------
5 1
Server /chassis/adapter/vmfex # show offload
TCP Segment Offload TCP Rx Checksum TCP Tx Checksum Large Receive
-------------------- ---------------- ---------------- -------------
enabled enabled enabled enabled
Server /chassis/adapter/vmfex # show rss
TCP Rx Side Scaling
--------------------
enabled
Server /chassis/adapter/vmfex #
VM FEX Settings
The following tables describe the VM FEX settings that you can view.
General Properties Settings
DescriptionName
A user-defined name for the VM FEX.Name
The maximum transmission unit, or packet size, that this VM FEX
accepts.
MTU
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
OL-28893-01 111
Managing Network Adapters
VM FEX Settings