User's Manual

PurposeCommand or Action
Enters the host Fibre Channel interface command
mode for the specified vHBA.
Server /chassis/adapter # scope host-fc-if
{fc0 | fc1 | name}
Step 3
Enters the persistent binding command mode for
the vHBA.
Server /chassis/adapter/host-fc-if # scope
perbi
Step 4
Disables persistent binding for the vHBA.Server /chassis/adapter/host-fc-if/perbi #
set persistent-lun-binding disable
Step 5
Commits the transaction to the system
configuration.
Server /chassis/adapter/host-fc-if/perbi #
commit
Step 6
This example disables persistent binding for a vHBA:
Server# scope chassis
Server /chassis # scope adapter 4
Server /chassis/adapter # scope host-fc-if fc1
Server /chassis/adapter/host-fc-if # scope perbi
Server /chassis/adapter/host-fc-if/perbi # set persistent-lun-binding disable
Server /chassis/adapter/host-fc-if/perbi *# commit
Server /chassis/adapter/host-fc-if/perbi #
Rebuilding Persistent Binding
Before You Begin
Persistent binding must be enabled in the vHBA properties.
Procedure
PurposeCommand or Action
Enters the chassis command mode.Server# scope chassis
Step 1
Enters the command mode for the adapter card at the
PCI slot number specified by index.
Server /chassis # scope adapter index
Step 2
The server must be powered on before you
can view or change adapter settings.
Note
Enters the host Fibre Channel interface command
mode for the specified vHBA.
Server /chassis/adapter # scope
host-fc-if {fc0 | fc1 | name}
Step 3
Enters the persistent binding command mode for the
vHBA.
Server /chassis/adapter/host-fc-if #
scope perbi
Step 4
Rebuilds the persistent binding table for the vHBA.Server /chassis/adapter/host-fc-if/perbi
# rebuild
Step 5
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
98 OL-28893-01
Managing Network Adapters
Rebuilding Persistent Binding